PCD stands for pitch circle diameter. It's the diameter of the circle that runs through the middle of every wheel stud or bolt hole. It's written after the number of studs, so 5x112 means 5 studs on a circle 112mm across.
In short
- Count your studs or bolt holes.
- 4, 6 or 8 studs: measure from the middle of one stud to the middle of the one straight across.
- 5 studs: measure between two studs next to each other, then multiply by 1.7013.
- Round to the nearest standard size.
Rather not measure? Choose your car in the vehicle finder. It shows your car's PCD, centre bore, thread size and whether it uses wheel bolts or wheel nuts.
Before you start
- A ruler or tape measure marked in millimetres. Calipers, a measuring tool with sliding jaws and a reading, are easier to read if you have them.
- The wheel off the car, so you can see the hub. Park on level ground with the handbrake on, and support the car on axle stands, never just a jack.
You can measure the back of the wheel instead. Its bolt holes sit on the same circle, so the steps are the same.
Hubs with 4, 6 or 8 studs
Each stud has another one straight across the hub from it, so you can measure the PCD directly.
- Pick a stud and find the one straight across from it.
- Measure from the middle of the first stud to the middle of the one opposite. That's your PCD.
The middle of a stud is hard to judge by eye. It's easier to measure from the left edge of one stud to the left edge of the other. The distance is the same.
Hubs with 5 studs
No stud sits straight across from another, so a measurement across the hub isn't the PCD. Measure between two studs next to each other instead, then multiply.
- Measure from the middle of one stud to the middle of the stud next to it, or from edge to the same edge. Call this A.
- Multiply A by 1.7013. That's your PCD.
For example, if A is 65.8mm: 65.8 × 1.7013 = 111.9, so the PCD is 112mm and the hub is 5x112.
The same method works for any number of studs. Measure two studs next to each other and multiply by:
- 4 studs: 1.4142
- 5 studs: 1.7013
- 6 studs: 2
- 8 studs: 2.6131
Rounding to a standard size
A measurement by hand is rarely exact. PCDs come in set sizes, such as 100, 108, 112, 114.3 and 120mm, so round yours to the nearest one.
Some sizes are close together, for example 5x112 and 5x114.3. If yours sits between two, measure again with calipers, or send us a message.
Some PCDs are given in inches. An inch is 25.4mm, so 5x4.5 is 5x114.3, 5x4.75 is 5x120.65 and 6x5.5 is 6x139.7.
When you order
In the builder, your PCD is step 2. On our ready-made Spacers it's the first part of the name, for example 5x112.
Check it against our list
The builder lists every PCD we make, grouped by the number of studs.
Not on the list? Send us a message