Measuring your centre bore

In this guide

Your hub has a raised ring in the middle, the hub lip, and your wheel has a hole in the middle that fits over it. Both are measured as a diameter, called the centre bore. The hub lip keeps the wheel centred on the hub, so a Spacer has to fit both.

In short

  1. Measure across the outside of your hub lip, with calipers.
  2. Measure across the inside of the hole in the middle of your wheel.
  3. Write down both. The Spacer fits over your hub, and your wheel fits over the Spacer.

The vehicle finder shows your car's centre bore. Aftermarket wheels often have a bigger hole than the hub, so if yours aren't the car's original wheels, measure them.

Centre boreHub lipBrake disc

Before you start

  • Calipers, a measuring tool with sliding jaws and a reading. Centre bores are given to a tenth of a millimetre or finer, for example 57.1 or 72.56, which is too fine to read on a ruler.
  • The wheel off the car. Park on level ground with the handbrake on, and support the car on axle stands, never just a jack.

Measuring your hub

  1. Clean any rust or dirt off the outside of the hub lip.
  2. Open the main jaws of the calipers over the lip, then close them until both jaws touch the sides.
  3. Move the calipers slowly across the lip and find the widest reading. That's your hub's centre bore.
Hub lipJaws touchingboth sides66.1

Measuring your wheel

  1. Lay the wheel face down on something soft.
  2. Put the small inside jaws of the calipers into the hole in the middle and open them until both touch the sides.
  3. Move them slowly across the hole and find the widest reading. That's your wheel's centre bore.
Your wheel'scentre boreInside jaws touchingboth sides73.1Wheel, cut throughthe middle

Some aftermarket wheels have a plastic or alloy ring pushed into the hole to make them fit the hub. Take it out before you measure.

How a Spacer fits both

A hubcentric Spacer has a bore on the back that fits over your hub lip, and its own lip on the front that your wheel fits over. The wheel stays centred on the hub, as it is without a Spacer.

Spacer's bore fitsyour hub lipSpacer's lip fits yourwheel's centre boreHub lipSpacer, cutin half

You can choose our Spacers with or without this lip. Whether it suits depends on your car: on thinner Spacers it often won't fit, because of how deep your hub lip is. See Measuring your hub lip.

When you order

In the builder, your hub's centre bore goes in step 4, Hub side (your car), and your wheel's in step 5, Wheel side (your wheels). Enter exactly what you measured, without adding or taking anything off. We make the Spacer to fit.

Our ready-made Spacers have the same centre bore for your hub and your wheel, shown in the name, for example 5x112 66.6mm. If your wheel's centre bore is different from your hub's, use the builder.

Find Spacers for your car

Pick your car, or build your own to your measurements.