Choosing a thickness

In this guide

A Spacer moves your wheel out by its own thickness. The right thickness brings the wheel out as far as you want, with room left at the wheel arch and at the strut.

In short

  1. Measure the room between your tyre and the wheel arch, and between your tyre and the strut.
  2. A Spacer uses up its own thickness of the room to the arch.
  3. Leave enough room for the wheel to move as the suspension and steering move.

Bolt On Spacer kits come in 20 to 60mm, and Slip On Spacers in 5 to 25mm.

SpacerWhere thewheel wasMoves out 25mmYour hub

What a Spacer changes

A 25mm Spacer moves the wheel 25mm further out. The gap to the strut on the inside grows by 25mm, and the gap to the wheel arch on the outside shrinks by 25mm.

It's the same as fitting a wheel with 25mm less offset. Offset, or ET, is how far the face of the wheel that sits on the hub is from the middle of the wheel, in millimetres. It's usually stamped on the back of the wheel, for example ET35. So a 25mm Spacer on an ET35 wheel puts it where an ET10 wheel would sit.

Before you start

  • A straight edge, such as a long steel rule or a spirit level.
  • A ruler or tape measure marked in millimetres.
  • The car on its wheels, on level ground, with the steering straight ahead.

Measuring how much room you have

  1. Hold the straight edge upright against the edge of the wheel arch, so it hangs down past the wheel.
  2. Measure from the straight edge to the part of the tyre or wheel that sticks out furthest. That's the room to the arch.
  3. On the inside of the wheel, measure the gap between the tyre and the strut (the suspension leg beside the tyre), or whatever is closest to the tyre. That's the room to the strut.
  4. Measure each corner. The front and rear often differ, and the left and right can too.
Wheel archStraightedgeRoom to thearchRoom to thestrutStrut

A Spacer can't be thicker than the room to the arch. Take the Spacer's thickness away from the room to the arch, and what's left is the room you'll have. The wheel also needs room to move as the suspension compresses and the steering turns.

So leave enough room that the wheel and tyre can't touch the suspension, the steering or anything else on the inside, or catch the wheel arch, as they move. How close you go is your decision, so check your car carefully before you choose a thickness.

Pairs, front and rear

Spacers come in pairs, one for each side of an axle, so both wheels on that axle move out by the same amount. For all four wheels, order two pairs. The front and rear pairs can be different thicknesses.

Our thicknesses

  • Bolt On Spacer kits: 20 to 60mm, in 5mm steps.
  • Slip On Spacers: 5 to 25mm. The thinnest depends on your PCD: 5mm up to 120.65mm, 10mm up to 140mm and 15mm up to 170mm.

Need a size in between? Build your own to your measurements. Not sure which type? See Bolt On or Slip On?

Before you order

Find Spacers for your car

Pick your car, or build your own to your measurements.