Measuring your hub lip

In this guide

The hub lip is the raised ring in the middle of your hub that the wheel centres on. Its depth is how far it stands out from the face the wheel sits on. A Spacer needs room for it, or it can't sit flat on the hub.

In short

  1. Clean the face around the hub lip.
  2. Measure how far the lip stands out from the face the wheel sits on, with a steel ruler or the depth rod of your calipers.
  3. Measure in two or three places and use the deepest reading.

The vehicle finder can't tell you this one, so it has to be measured.

Lip depthHub lipFace the wheelsits onBrake disc

Before you start

  • A steel ruler, or calipers with a depth rod (the thin rod that slides out of the end).
  • The wheel off the car. Park on level ground with the handbrake on, and support the car on axle stands, never just a jack.

Measuring with a ruler

  1. Clean any rust or dirt off the face around the lip.
  2. Hold the ruler along the top of the lip, with its end flat against the face the wheel sits on.
  3. Read the ruler where the lip ends. That's your lip depth.
1020304050End of the ruleragainst the faceRead it wherethe lip endsHub lipFace the wheel sits on

Measuring with calipers

  1. Rest the end of the calipers on the end of the lip.
  2. Slide the depth rod out until it touches the face the wheel sits on.
  3. Read the display. That's your lip depth.
End of the caliperson the lipDepth rod on the face15.0Hub lip

Measure in two or three places round the lip and use the deepest reading.

Why it matters

A hubcentric Spacer has a recess on the back for the hub lip. The recess has to be at least as deep as the lip, so the Spacer sits flat on the face.

Lip depthRoom for the lipHub lipSpacer, cutin half

If the lip is deeper than the recess, the Spacer is held off the face and can't be fitted. A thicker Spacer has a deeper recess.

If your hub lip is too deep

You have two options:

  • A thicker Spacer, with a deeper recess.
  • A Spacer without the hubcentric lip. Its hole doesn't narrow, so your hub lip can pass right through it, however deep it is.

Without the lip, the Spacer doesn't centre the wheel, so we recommend the lip wherever it fits.

When you order

When you choose the hubcentric lip, on a Spacer page or in step 5 of the builder, we ask about your hub lip depth, so we can check the Spacer has room for it. Use the depth you measured.

Find Spacers for your car

Pick your car, or build your own to your measurements.