AN fittings join hoses and hard lines (metal pipes) for fuel, oil and coolant. Each size has a dash number, such as -8, also written AN8 or AN-8. Fittings only fit each other at the same dash size.
In short
- The dash number is the size. Fittings only fit the same dash size.
- AN fittings seal on a 37° cone, so the threads don't need tape or sealant.
- To find a size, measure across the thread with calipers and check the table below.
What the dash number means
The dash number is the outside diameter of the matching hard line, in sixteenths of an inch. A -8 fitting suits 8/16in, or 1/2in, line. It isn't the size of the thread: each dash size has its own thread, shown in the table below.
How AN fittings seal
An AN fitting seals metal to metal, on a 37° cone on the end of the male fitting. The nut only holds the two cones together, so the threads don't need tape or sealant.
Some fittings look the same but have a 45° cone, called SAE flare, and several sizes even share the thread. They don't seal against a 37° AN fitting, so don't mix them.
NPT (pipe) threads can look similar too. They're tapered, getting wider along the thread, and seal on the thread with sealant. They don't fit AN or ORB ports.
ORB fittings
ORB (O-ring boss) fittings screw into a port, for example on a filter housing or a pump. The thread is the same as the AN thread of the same dash size, but an O-ring under the hex does the sealing. It's squeezed into a chamfer round the mouth of the port. An ORB to AN adapter takes you from a port to an AN hose end.
Some fittings press in rather than screw in, such as our rocker cover fittings in AN10 and AN12.
Finding the size of a fitting
- Measure across the outside of the thread with calipers, a measuring tool with sliding jaws and a reading.
- Find the nearest size in the table. A thread measures a little under its size, so 19.0mm is a -8.
| Dash size | Line size | Thread | Across the thread |
|---|---|---|---|
| -3 | 3/16in (4.8mm) | 3/8-24 | 9.5mm |
| -4 | 1/4in (6.4mm) | 7/16-20 | 11.1mm |
| -6 | 3/8in (9.5mm) | 9/16-18 | 14.3mm |
| -8 | 1/2in (12.7mm) | 3/4-16 | 19.1mm |
| -10 | 5/8in (15.9mm) | 7/8-14 | 22.2mm |
| -12 | 3/4in (19.1mm) | 1-1/16-12 | 27.0mm |
| -16 | 1in (25.4mm) | 1-5/16-12 | 33.3mm |
| -20 | 1-1/4in (31.8mm) | 1-5/8-12 | 41.3mm |
A thread written 3/4-16 is 3/4in across with 16 threads to the inch.